Jumpstart the Car
Sometimes we get a problem likes dead battery in our car. In emergency situation likes in public places where no workshop found, we have to jumpstart the car.
Before attempting to jumpstart your car, you will need a car with the same voltage battery as your car and it should be fully charged or in a good condition. Then prepare a set of the jumper cable. It should be two cables and have a big size, bacause it needs very high current to start the car. It is up to about 400 amperes.
For the first step, attach one end of the jumper cable to the positive terminal of dead battery. Attach the other end to the positive terminal of battery of starting car.
Take the other jumper cable and attach one end of the jumper cable to the negative terminal of battery of starting car. Attach the other end to the negative terminal of dead battery.
Remember, in whatever jumpstart the car (battery) attach the positive terminal first. It is safely step.
Be sure that all of the end of jumper cable attached firmly.
Then start the car with a good battery. After a few minutes start the car with the dead battery.
The car with the dead battery should start by now.
In this case, the cause of dead battery is battery lifes. Battery lifes is usually about one and half years. If you get your car hard to start, you should check your battery.
Other posts you might like:
Choose Your Car Battery
Oil Change
Maintenance of Car Battery
Diagnostic of Engine Noise
3 Responses to “Jumpstart the Car”
Percfet shot! Thanks for your post!
Thanks before
Well,wait for else from me
Thanks for spending time on the computer (wriintg) so others don’t have to.